4 Mono Inputs XLR or TRS jack connector, gain, 4 band EQ with swept mids, HPF @ 100Hz, 6 aux sends (1-4 pre, 5&6 switchable pre/post fader), pan, peak signal led, cue and on button with led. 100mm long throw fader.
Insert point and direct output on TRS jack 6 Dual Stereo Channels 2 stereo sources (A & B) per channel. A is on RCA for all channels with RIAA preamps on CH 5,6,9,10. B inputs are line in on RCA CH 5 & 10 and TRS on CH 6,7, 8 & 9. Access to all 6 auxes is at the top of the channels, leaving performance area clear.
3 colour bar meter and gain control.
Powerful 4 band EQ with on switch.
60mm fader and X-fade assign section
Stereo Mix Outputs 2 independent mix outputs with level controls, 12 segment 3 colour led metering and insert.
Balanced XLR plus secondary RCA outputs, plus selectable mono out also on XLR and TRS. CH1-4 feed mix1 or mix2.
Stereo channels feed mix1 direct or via the X-fader. Mix1 can route to mix2
6 Auxiliary Sends 6 aux sends to [TRS] outputs for monitors or FX sends. Mic / line CH 1-4 have individual sends and stereo CH 5-10 have aux 1&2 individual mono sum and auxes 3&4, 5&6 paired with L to odd, R to even. Aux sends 1-4 are always prefade, while auxes 5&6 are switchable pre/post fader.
Additional controls allow aux sends to track the X-fader post fade 4 Stereo 2 Mono Mix1, mix2, post x-fader aux 3&4 and 5&6 can provide stereo mixes on rotary controls. Post x-fader aux 1 & aux 2 can Zone Outs provide mono mix outputs with level controls
4 Band EQ Mono channels have 2 swept frequency mids. Stereo channels have EQ-on switch and all frequency sections have +6dB boost to preserve headroom and -26dB cut for creative mixing
VCA Cross Fader Conductive plastic, high quality 45mm Penny & Giles fader with curve switchable to cut or dip.
Stereo channels can be assigned to X (left) side with green led indication or Y (right) side with yellow led. VCA operation means wear and tear does not affect audio.
Pan trim control for imbalance Voltage Controlled Filters 2 filters [1 for each side of the x-fader] with choice of High Pass, Band Pass, Low Pass or multiples e.g. notch.
Resonance control - adjusts Q from ‘mild to wild’.
Sweep controls from 100Hz to 20kHz with blue led on switch
External Input TRS jack inputs via level control to mix1, mix2 or monitor
Engineer / DJ's Toolbox 2 high powered headphone outputs with level. Booth output on TRS with level. Monitor section has 8-way switch bank to select monitor source.
12 segment 3 colour bar metering.
Channel cue overrides the monitor selected in the phones [and booth if Cue Enable is pressed].
Split Cue sends cue signals to left and selected program to right.
Mute kills local monitor output [option for -20dB action].
Mono sum button for phase and compatibility check PSU High performance internal switched-mode power supply.
Universal mains input voltage Configuration Options Internal links: mono CH aux sends to pre-EQ and / or pre-ON.
Stereo CH Cue to post EQ. Stereo CH auxes to pre-EQ. Direct out to pre-fade.
EXT in -10dBV/+4dBu. Monitor Mute to -20dB attenuator.