Ortofon OM Qbert Kit with Extra Stylus
Designed together with DJ QBert for scratch and back curing, this needle has a very good ability to find the grove and stay there. It uses a spherical diamond and enables a very high output (10 11 mV). Comes with an extra Q.Bert stylus.
Several Ortofon technologies make it possible to realize high sound quality and low record wear at the high tracking forces that are necessary in disco environments. DJs all over the world claim very high demands to their professional equipment, among which the cartridges plays their decisive part by realizing that scratching, back-cueing, and live artistic performance are a big part of the show. Reliability and robustness is vital, when the cartridges night after night will have to withstand these demands in environments with extreme sound pressure and vibration.
Scratching and back-cueing impose heavy mechanical stress on the cantilever and its rubber bearing. Therefore, the Ortofon disco cartridges are equipped with cantilevers made from aluminum tube with increased wall thickness. Special attention has also been paid to the attachment of the bearing and the design of the bearing itself. This means that rough treatment will neither damage the cartridge nor degrade its stability.
For easier cueing, the nose of all the Ortofon disco cartridges have an extra large cut-out which makes the stylus freely visible from above, and further, the tip of the cantilever is fluorescent.
Output voltage at 1000 Hz. 5cm/sec.: 11 mV
Channel balance at 1 kHz: 1.5 dB
Channel separation at 1 kHz: 22 dB
Channel separation at 15 kHz: -
Frequency range: 20-20.000 Hz
Frequency response: 20-20.000 Hz -3 dB
FIM distortion at recommended tracking force, DIN 45.542: